1.2.4.4. The rfcomm_channel Parameter -- Specifying the Channel Number of the RFCOMM Connection between the PC and Mobile Phone
The rfcomm_channel parameter specifies the channel number used by the RFCOMM connection between the mobile phone and the PC. The default value is 1. Here is an example. To set the RFCOMM channel number to 3, include this line in Gnokii's configuration file:
rfcomm_channel = 3
You can ignore this parameter if you are not going to use Bluetooth and RFCOMM to connect the mobile phone to the PC.
| Previous Page | Page 7 of 12 | Next Page |  |
Contents at a Glance (Click Here for Full Table of Contents)
- 1. How to Use a Linux PC to Send and Receive SMS Messages (Non-Developer's Perspective)
- 1.1. Requirements for Sending and Receiving SMS Messages from a Linux PC via a Mobile Phone
- 1.2. Using Gnokii to Send and Receive SMS Messages from a Linux PC
- 1.2.1. Introduction
- 1.2.2. Mobile Phone Models Supported by Gnokii
- 1.2.3. Installing Gnokii / XGnokii
- 1.2.4. Configuring Gnokii / XGnokii on Linux
- 1.2.5. Examples
- 1.2.6. Testing Gnokii on Linux
- 1.2.7. Sending SMS Text Messages with XGnokii on Linux
- 1.2.8. Receiving SMS Text Messages with XGnokii on Linux
- 1.2.9. Importing and Exporting Phone Book Entries with XGnokii on Linux
